Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Members List

gavinator68 gavinator68 is offline

Senior Member

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. TomG
    10-09-2014 02:35 PM
    TomG
    David,
    That is a marine-grade 1/4"plywood with a teak/holly veneer. You can probably find it nearby given the all the boating activity in your area. It isn't cheap as I paid $115 for a 4x8 sheet. I finished the surface with Helmsman Spar Urethane and it has held up well considering the abuse heaped upon it. Urethane is pretty tough stuff and most everything that has spilled has come off even a couple of drips of Brightside urethane. The original flooring Tartan put in was cork, which is kind of nice under foot, but it gets dirty quickly. I also looked at the new faux-teak stuff (NuTeak, FlexiTeak), but that stuff is really expensive. Overall, I've been happy with the teak/holly veneer. If I had it to do over again, I'd most likely go with the same thing. Shoot me a note anytime as you work through your projects. I've done a LOT of them this past 18 months!

Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 08-13-2015 02:13 PM
  • Join Date: 09-28-2014

All times are GMT -4. The time now is 04:56 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved