Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Members List

jwmurphy jwmurphy is offline

Senior Member

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. jwmurphy
    09-06-2017 12:01 PM
    jwmurphy
    If the engine runs on starter fluid and the carburetor is clean I too would think its a fuel supply problem.

    I have experienced the float valve needle sticking closed stopping fuel flow into the carburetor/float bowl . You should be able to blow into the carburetor through the main fuel inlet, if not the needle is stuck closed. Don's manual has a section on how to address the float valve seating surface.

Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 01-31-2019 11:51 AM
  • Join Date: 10-13-2012

All times are GMT -4. The time now is 02:56 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved