Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Members List

Robert Bleiler Robert Bleiler is offline

New Member

Visitor Messages

Showing Visitor Messages 1 to 3 of 3
  1. Robert Bleiler
    07-14-2015 10:02 AM
    Robert Bleiler
    Finding neutral
    I ave just gone through my reversing gear. I have a real solid forward. My reverse is just about at the end of the cable travel. I can feel where neutral should be because I can easily rotate the shaft in either direction; but when I start the engine leaving the reverse gear lever where neutral should be (no resistance in either direction) the shaft spins quickly in that position. With the engine running I can find no place where the reverse gear lever slows down the shaft spin significantly. I am happy with my forward and reverse and feel that my cable is functioning correctly,but I sure would like to get a better neutral. Thanks, Bob
  2. Robert Bleiler
    07-08-2015 03:24 PM
    Robert Bleiler
    finding neutral
    I have just gone through my reversing gear. I have a real solid forward. My reverse is just about at the end of my cable travel. I can feel where neutral should be because I can easily rotate the shaft in either direction; but when I run the engine leaving the shifter where neutral should be (no resistance in either direction), the shaft spins quickly at that position. With the engine running I can find no place where the gear shifter slows down the shaft spin significantly. I am happy with my forward and reverse, but I sure would like to get a better neutral. Thanks, Bob
  3. Robert Bleiler
    06-26-2015 04:04 PM
    Robert Bleiler
    finding neutral
    I have just gone through my reversing gear. I have a real solid forward. My reverse is just about at the end of my cable travel. I can feel where neutral should be because I can very easily rotate the shaft in either direction; but when I run the engine leaving the shifter where neutral should be ( no resistance in either direction ), the shaft spins quickly at that position. With the engine running I can find no place where the gear shifter slows down the shaft spin significantly.I am happy with my forward and reverse, but I sure would like to get a better neutral. Any ideas? Thanks, Bob

Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 06-11-2016 10:06 AM
  • Join Date: 03-04-2014

All times are GMT -4. The time now is 05:20 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved