Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Members List

Yankee30 Yankee30 is offline

Frequent Contributor

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. Yankee30
    07-08-2019 11:47 AM
    Hello there!

    Issue: In neutral and in Reverse I get normal rev and oil pressure, just not in forward gear.

    New Plugs
    New Ignition Coil
    Compression Test after about 10min running (95 - 96 - 95 - 100)
    New Racor Fuel Filter
    Oil Change
    New Carb (installing now)
    Checked Exhaust Aft from Engine

    The Throttle Lever on the new Carb is oriented differently than the one the old carb. With my cable configuration (Coming to engine from aft - no u-turn) The cables are not oriented to push throttle open and pull closed.

    The old carb has a Throttle Arm which was oriented differently supporting the normal functioning of my throttle cable.


    1.) Any other things you would look at regarding the power issue in Forward Gear?
    2.) Can I use the old throttle arm from original and new plate and screws? (it seems to fit the same and solves the issue)
    3.) Is there a way to invert the throttle arm which came with the new Zenith. I can't find a way to flip it.


Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 08-04-2019 06:01 PM
  • Join Date: 07-02-2019

All times are GMT -4. The time now is 05:59 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.

Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2019 Moyer Marine Inc.

All Rights Reserved