Showing Visitor Messages 1 to 2 of 2
-
Hey guys, once again I need a little input since my manual has not showed up yet. I removed the plate off the fly wheel housing because I had an oil leak when the motor was running. I removed the fly wheel housing and replaced the gasket. But my question is, it looks like there should be some type of O ring around the center hole of the fly wheel housing, where it goes around the end of the crankshaft end.
If there should be one, it is missing and I couldn't find any O rings on Moyers catalog of parts.
Can you possible bring me up to speed on what should be there?
Thanks again,
freebird
-
I haven't owned my Atomic 4 too long. It came in my Morgan 30. It had been stored dry with no oil. I have pulled it and replaced hoses and electrical. Also have ordered a service book that hasn't shown up as of yet. 2 questions:
What is the plug gap for the Atomic 4?
And where can I tap in an oil pressure gauge in the block?
I have test ran it but I need to be able to check the oil pressure before I put it back in the boat.
Thanks for any help.