Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Members List

freebird freebird is offline

Member

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. freebird
    02-07-2012 12:50 AM
    freebird
    Hey guys, once again I need a little input since my manual has not showed up yet. I removed the plate off the fly wheel housing because I had an oil leak when the motor was running. I removed the fly wheel housing and replaced the gasket. But my question is, it looks like there should be some type of O ring around the center hole of the fly wheel housing, where it goes around the end of the crankshaft end.
    If there should be one, it is missing and I couldn't find any O rings on Moyers catalog of parts.
    Can you possible bring me up to speed on what should be there?
    Thanks again,
    freebird
  2. freebird
    01-01-2012 12:22 AM
    freebird
    I haven't owned my Atomic 4 too long. It came in my Morgan 30. It had been stored dry with no oil. I have pulled it and replaced hoses and electrical. Also have ordered a service book that hasn't shown up as of yet. 2 questions:
    What is the plug gap for the Atomic 4?
    And where can I tap in an oil pressure gauge in the block?
    I have test ran it but I need to be able to check the oil pressure before I put it back in the boat.
    Thanks for any help.

Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 02-16-2012 12:03 AM
  • Join Date: 12-05-2011

All times are GMT -4. The time now is 05:21 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved