Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > SeaFever

Conversation Between SeaFever and Dick Cook
Showing Visitor Messages 1 to 2 of 2
  1. SeaFever
    03-30-2010 11:15 AM
    SeaFever
    Dick,

    Correct. Since you have the A4 and that requires a much heavier gauge clutch cable It will be a challenge to fix that cable along with the 33C series cable required for the throttle. However if you speak with Edson they may have a solution. Perhaps the other Engine control assembly with the long lever for clutch instead of the lever similar to the throttle.

    Check out the engine control assy no. 751/816 from Edson. That might work. Just a thought. This forum does not allow me to attach docs in the private messages. I can attach the document if you reply in the main message board.
  2. Dick Cook
    03-29-2010 12:09 AM
    Dick Cook
    Thanks for the info on your project. If I go with this new system, the clutch cable could be a challenge.
    Dick

All times are GMT -4. The time now is 07:48 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved